![]() Then open, edit and transmit file OEM.SYS back to the device. Enter the key for PLC Access (default: 807667). After connecting to your controller type in ‘PLC:\’ into the lower Explorer Bar. This file can be accessed from your PC with Heidenhain TNCREMO (free). If the soft key is not shown you can make it visible by inserting or uncommenting the following entry in file OEM.SYS: If a dialog opens, select ‘Machine settings -> External access’ and check if soft key ‘External access’ at the bottom is set to ‘Yes’. To avoid that you cannot access the controller or get login errors you first have to make sure that external access is enabled in general: See our how-to instructions on setup of data acquisition in this case.įIG 1: Heidenhain TNC 640 CONTROLLER SETUP Note: This diagnostic program can be used without Heidenhain Option 18 (DNC).To read/write data from/to machines with Heidenhain TNC/iTNC controllers connected to CNCnetPDM with your applications you can use our free Open Source Client (C-Sharp) together with the CNCnetPDM Heidenhain TNC/iTNC device driver.This document describes setup and test of data acquisition from Heidenhain iTNC 530, TNC 426, 430, and newer NCK based 320, 620, 640 controllers.ĬONTROLLER SETUP | SOFTWARE DOWNLOAD | LICENSING | SOFTWARE SETUP
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |